The XeroStar "Rondo" Separator Unit

FACTORY SUCTION UNIT
water/air separator 

The water/air inlet is at centre right
The air/vacuum outlet is at top right
The water outlet is at the base

The compact size: 
450mm high  x  260mm diam.

The XeroStar "Rondo" Separator Unit 

FACTORY SUCTION UNIT
water/air separator with water tank

The water/air inlet is at centre right 
The air/vacuum outlet is at top right
The water outlet is at the base

Capacity of this model is 20 litres. It will separate 20 litres of water/ minute.
The long tank allows fast drainage of accumulated water.
Two of these units working in a "see-saw" connection allow continuous separation.

The compact size: 145 cm high  x  260mm diam.
 

The XeroStar "Rondo" Vacuum Unit

FACTORY SUCTION UNIT

250Volt AC

1300 Watts of 
Suction Power!

The electrical connection is a universal surface mounted male socket as shown at left of the decal.

The electric motor cooling is assisted by the compressed air feed at top inlet The cooling air exits at a side vent

The unit is supported by two large circlamps with rubber cushioning to reduce vibration

Vacuum inlet is at the bottom intake (40mm ID)
Vacuum air exits from the oblique side vanes as shown

The compact size:  470mm high  x  170mm diam
 

The Xerostar 
Electronic Control Module

250Volt AC

This Module has 2 inputs:
a) for the float switch
 b) remote on/off switch

A timer is provided with a variable delay setting as well as a built in on/off switch and main power fuse.

The size: 
170mm long  x  170mm wide  x  45mm deep